Omron R88D-1SN ECT Series User Manual

41
Related Manuals
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User’s Manual (I586)
NJ-series CPU
Unit Hardware
User’s Manual
W500 NJ501-
NJ301-
NJ101-
Learning the basic speci-
fications of the NJ-series
CPU Units, including
introductory information,
designing, installation,
and maintenance.
Mainly hardware infor-
mation is provided.
An introduction to the entire
NJ-series system is provided
along with the following infor-
mation on the CPU Unit.
• Features and system con-
figuration
• Introduction
• Part names and functions
• General specifications
• Installation and wiring
• Maintenance and inspec-
tion
Use this manual together
with the NJ-series CPU Unit
Software User’s Manual
(Cat. No. W501).
NJ/NX-series CPU
Unit Software
User’s Manual
W501 NX701-
NX1P2-
NJ501-
NJ301-
NJ101-
Learning how to program
and set up an
NJ/NX-series CPU Unit.
Mainly software informa-
tion is provided.
The following information is
provided on a Controller built
with an NJ/NX-series CPU
Unit.
• CPU Unit operation
• CPU Unit features
• Initial settings
• Programming based on
IEC 61131-3 language
specifications
Use this manual together
with the NX-series CPU Unit
Hardware User's Manual
(Cat. No. W535) or NJ-series
CPU Unit Hardware User's
Manual (Cat. No. W500).
NJ/NX-series CPU
Unit
Built-in Ether-
CAT® Port
User’s Manual
W505 NX701-
NX102-
NX1P2-
NJ501-
NJ301-
NJ101-
Learning how to config-
ure the EtherCAT com-
munications system.
Describes setup procedures
for building the EtherCAT
communications system.
NJ/NX-series CPU
Unit Motion Con-
trol User’s Manual
W507 NX701-
NX1P2-
NJ501-
NJ301-
NJ101-
Learning about motion
control settings and pro-
gramming concepts.
The settings and operation of
the CPU Unit and program-
ming concepts for motion
control are described.
When programming, use this
manual together with the
NX-series CPU Unit Hard-
ware User's Manual (Cat.
No. W535) or NJ-series CPU
Unit Hardware User's Man-
ual (Cat. No. W500) and with
the
NJ/NX-series CPU Unit
Software User's Manual
(Cat. No. W501).
Manual name Cat. No. Model numbers Application Description

Omron R88D-1SN ECT Series Specifications

General

Feedback	Incremental encoder, Absolute encoder
Position Control	Yes
Speed Control	Yes
Torque Control	Yes
Communication Interface	EtherCAT
Power Supply Voltage	200 to 240 VAC
Output Power	0.1 to 1.5 kW
Input Voltage Range	170 to 264 VAC
Control Method	Sine-wave PWM control
Main Circuit Power Supply	200-240 VAC
Applicable Motor Capacity	0.1 to 1.5 kW
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Encoder Error
Ambient Operating Temperature	0 to 55°C
Vibration Resistance	4.9 m/s² (10 to 55 Hz)
Shock Resistance	98 m/s2
Weight	Varies by model