U 3 Features
3-168 Features
Conditions • UCD can be used in the following cases:
a) The floating number of UCD is assigned as the Direct In Lines
(DIL) 1:1 destination.
b) The floating number of UCD is assigned as the Intercept Routing
destination.
c) The floating number of UCD is dialed from an extension.
d) The floating number of UCD is dialed from DISA (Direct Inward
System Access)
• This feature requires assigning an UCD group in System Programming.
An extension cannot belong to two or more UCD groups.
• The floating number can be assigned on an UCD group basis. The
UCD group is based on the extension group.
• It is possible to set the log-in or log-out status on an extension basis.
An UCD call can be sent to an extension in log-in status within the
UCD group, but cannot be sent to extensions in log-out status. If the
extension would like to leave the group temporarily, the extension sets
the log-out status by the feature number to prevent UCD calls being
sent to his/her extension. When the extension re-joins the group, the
extension sets the log-in status.
• There should be at least one extension that is in log-in status.
Programming References
Section 4, System Programming
[106] Station Hunting Type
[602] Extension Group Assignment
[813] Floating Number Assignment
Feature Reference Section 3, Features
Extension Group Station Hunting
Log-In / Log-Out
Operation References DPT Features, Standard Telephone Features
—User Manual Uniform Call Distribution (UCD)
To Next Page
Loading...
