4.7 COS Programming
Call Transfer to Outside Line
503
System Programming 4-113
Description This program determines which Classes of Services (COS) are
allowed to perform the Call Transfer to Outside Line function.
Selection • COS number: 1 through 8, ( =all COS)
• Enable / Disable
Default All COS – Disable
Programming 1. Enter 503.
Display: 503 CALL XFER CO
2. Press NEXT.
Display: COS NO?→
3. Enter a COS number.
To enter COS number 1, you can also press NEXT.
Display example: COS1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another COS, press NEXT or PREV, or
SELECT and the desired COS number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all COS to one selection, press the key in step 3. In this
case, the display shows the contents programmed for COS 1.
• Program [601] “Class of Service” is used to assign a Class of Service to
each extension.
Feature References Section 3, Features
Call Transfer, Screened – to Outside Line
To Next Page
Loading...
