4.6 Outside Line Programming
DIL 1:1 Extension — Day / Night
407-408
System Programming 4-101
Description The Direct In Lines (DIL) 1:1 feature allows incoming outside calls
to be directed to a specific extension. When an outside line is
assigned as DIL 1:1, it is necessary to assign the destination. These
programs specify the extension number for day or night mode.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Extension number: 2 through 4 digits / Disable (no DIL 1:1)
Default All outside lines – Disable — Day / Night
Programming 1. Enter a program address (407 for day or 408 for night).
Display example: 407 DIL 1:1 DAY
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:Disable
4. Enter an extension number.
To change the current entry, press CLEAR and enter the new number.
To disable DIL 1:1, press CLEAR.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions •
To assign all outside lines to one selection, press the key in step 3. In
this case, the display shows the contents programmed for outside line 1.
•
You set the extension numbers in program [003] “Extension Number
Set”, voice mail extension numbers in program [118] “Voice Mail
Extension Number Assignment”, phantom extension numbers in program
[124] “Phantom Extension Number Assignment” or floating numbers of
pager(s), DISA (Direct Inward System Access) message(s) and extension
group(s) in program [813] “Floating Number Assignment”.
• If an outside line is also programmed for DIL 1:N in programs
[603]–[604] “DIL 1:N Extension and Delayed Ringing — Day / Night”,
it is regarded as a DIL 1:1 line.
Feature References Section 3, Features
Direct In Lines (DIL) Night Service
Direct Inward System Access (DISA)
To Next Page
Loading...
