4.6 Outside Line Programming
Caller ID Assignment
406
4-100 System Programming
Description Enables the Caller ID feature for the outside lines to which a Caller
ID Service is offered by a Central Office by contract.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Enable / Disable
Default All outside lines – Disable
Programming 1. Enter 406.
Display: 406 CALLER ID CO
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all outside lines to one selection, press the key in step 3.
In this case, the display shows the contents programmed for outside line
1.
• The following programs are used to program Caller ID feature: [110]
“Caller ID Code Set” and [111] “Caller ID Name Set”.
Feature References Section 3, Features
Caller ID
To Next Page
Loading...
