4.3 System Programming
Caller ID Name Set
111
4-44 System Programming
Description With Caller ID Service, the calling party is displayed either by its
ID Code or by its name. If the name display is required, use this
program to give a name to a caller ID Code stored in program [110]
“Caller ID Code Set”.
Selection • Location number: 001 through 100
• Caller ID Name: 15 characters (max.)
Default All locations – Not stored
Programming 1. Enter 111.
Display: 111 CALLER NAME
2. Press NEXT.
Display: Location NO?→
3. Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: 001:Not Stored
4. Enter a Caller ID Name.
For entering characters, see Section 4.1.3 “Entering Characters”.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new name.
5. Press STORE.
6. To program another location, press NEXT or PREV, or
SELECT and the desired location number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Caller ID Name corresponds to the Caller ID Codes stored in program
[110] “Caller ID Code Set”.
• Each name has a maximum of 15 characters.
Feature References Section 3, Features
Caller ID
To Next Page
Loading...
