System Programming 4-7
4.1.2 Programming Methods
Example;
NEXT NEXT NEXT
#1-1 #1-2 #2-1 #2-2 ......
PREV PREV PREV
Advancing to the next stage
When “SYS-PGM NO? →” is displayed, you can select one of the
following:
• To go to program [000], press the NEXT button.
• To go to another program, enter the 3-digit program address.
Rotation of jack number
Each jack of the Digital Super Hybrid System supports the
connection of a digital proprietary telephone and a single line
device with different extension numbers (eXtra Device Port: XDP
function). To program this function it is necessary to assign two
parts for each jack. The first part of jack one is 1-1. The second
part of jack one is 1-2. The first part of jack two is 2-1 and so on.
The NEXT and PREV buttons can be used to move from jack to
jack as required in programs [003], [004] and [601] through [610].
Note The first part of a jack is for a DPT of a XDP-assigned jack. The second
part is for a single line device. Program [600] “EXtra Device Port”
assigns which jacks are XDP.
Storing your data
Press STORE to store your data.
• The STORE indicator lights red and a confirmation tone is
emitted.
* Confirmation tone (one beep)
After pressing STORE, you will hear a beep. This informs you
that storage is completed.
* Alarm tone (three beeps)
If you hear this alarm, your entry is not valid.
Making another selection within the same program address
• To make the next higher selection, press NEXT.
• To make the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the
number.
To Next Page
Loading...
