Panasonic KX-TD308 - CPC Signal Detection Incoming Set

4.6 Outside Line Programming
CPC Signal Detection Incoming Set
405
System Programming 4-99
Description Assigns the expected minimum duration of the Calling Party
Control (CPC) Signal on incoming outside calls. If this is
programmed, the system disconnects the line when the CPC Signal
is detected.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Time (milliseconds): Disable (no detection) / 100 / 200 / 300 /
400 / 500 / 600
Default All outside lines – 400 ms
Programming 1. Enter 405.
Display: 405 CPC INCOMING
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:400msec
4. Keep pressing SELECT until the desired time is displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all outside lines to one selection, press the key in step 3.
In this case, the display shows the contents programmed for outside line
1.
• You may disable CPC Signal Detection for an outside line.
• Program [415] “CPC Signal Detection Outgoing Set” is used to
program CPC Signal Detection for outgoing outside calls.
Feature References Section 3, Features
Calling Party Control (CPC) Signal Detection
Direct Inward System Access (DISA)