System Programming 4-23
4.2 Manager Programming
Extension Name Set
004
Description Assigns names to the extension numbers programmed in program
[003] “Extension Number Set”.
Selection • Jack number: 1 through 8 (-1 / -2)
(-1 = first part, -2 = second part)
• Name: 10 characters (max.)
Default All jacks – Not stored
Programming 1. Enter 004.
Display: 004 EXT NAME SET
2. Press NEXT.
Display: Jack NO?→
3. Enter a jack number.
To enter jack number 1, you can also press NEXT.
To select the second part (-2), press NEXT after entering a jack number.
Display: #1-1:Not Stored
4. Enter a name.
For entering characters, see Section 4.1.3 “Entering Characters”.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new name.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or
SELECT and the desired jack number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • There is a maximum of 16 names. Each name has a maximum of 10
characters.
• Program [003] “Extension Number Set” is used to assign extension
numbers.
• For an explanation of jack numbering, see “Rotation of jack number”
on page 4-7.
Feature References Section 3, Features
Display, Call Information
Intercom Calling
Special Display Features — Call Directory
To Next Page
Loading...
