4.3 System Programming
Phantom Extension Number Assignment
124
System Programming 4-55
Description Assigns the phantom extension numbers. Each number will be
assigned to a flexible CO or DSS (Direct Station Selection) button
and used as a Phantom Extension button.
Selection • Location number: 01 through 16
• Phantom extension number: 2 to 4 digits
Default All locations – Not stored
Programming 1. Enter 124.
Display: 124 PHANTOM #
2. Press NEXT.
Display: Location NO?→
3. Enter a location number.
To enter location number 01, you can also press NEXT.
Display example: 01:Not Stored
4. Enter a phantom number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new number.
5. Press STORE.
6. To program another location, press NEXT or PREV, or
SELECT and the desired location number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Each phantom number has two to four digits, consisting of numbers 0
through 9.
• The first one or two digits of the phantom extension numbers are
subject to program [100] “Flexible Numbering, (01) through (16) 1st
through 16th hundred extension blocks”.
• Phantom extension numbers and other extension numbers should be
unique. Double entry and incompatible entry for these numbers are
invalid. Valid entry example: 10 and 11, 10 and 110. Invalid entry
example: 10 and 106, 210 and 21.
To avoid making an invalid entry, check the other extension numbers in
programs [003] “Extension Number Set”, [118] “VM Extension
Number Assignment” and [813] “Floating Number Assignment”.
Feature References Section 3, Features
Phantom Extension
To Next Page
Loading...
