4.8 Extension Programming
EXtra Device Port
600
4-120 System Programming
Description EXtra Device Port (XDP) allows a standard telephone to be
connected to the same jack as a digital proprietary telephone
(DPT). This program assigns which jacks are XDP. The standard
telephone and DPT of the programmed jack work as independent
extensions.
Selection • Jack number: 1 through 8, ( =all jacks)
• Disable / Enable
Default All jacks – Disable
Programming 1. Enter 600.
Display: 600 XDP PORT
2. Press NEXT.
Display: Jack NO?→
3. Enter a jack number.
To enter jack number 1, you can also press NEXT.
Display example: #1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or
SELECT and the desired jack number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all jacks to one selection, press the key in step 3. In this
case, the display shows the contents programmed for Jack 1.
• Immediately after changing your assignment, the changed setting may
not work for a maximum of eight seconds.
Feature References Section 3, Features
EXtra Device Port (XDP)
To Next Page
Loading...
