Panasonic KX-TD308 - CPC Signal Detection Outgoing Set

4.6 Outside Line Programming
CPC Signal Detection Outgoing Set
415
4-108 System Programming
Description Enables or disables Calling Party Control (CPC) Signal Detection
during the time between the originated outside call and the
established outside call. If this is enabled, the system disconnects
the line with the time set in program [405] “CPC Signal Detection
Incoming Set” when the CPC Signal is detected.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Enable (detection) / Disable (no detection)
Default Disable
Programming 1. Enter 415.
Display: 415 CPC OUTGOING
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Some central offices (CO) may send CPC-like signals during the dialing
sequence and an attempt to make a call may be terminated. If your CO
is such a type, select “Disable”.
• Program [405] “CPC Signal Detection Incoming Set” is used to set
CPC Signal Detection Time.
•
To assign all outside lines to one selection, press the key in step 3. In
this case, the display shows the contents programmed for outside line 1.
Feature References Section 3, Features
Calling Party Control (CPC) Signal Detection
Direct Inward System Access (DISA)