4.9 Resource Programming
System Data Printout
802
4-132 System Programming
Description Starts or stops printing the system data. All or a specific range of
the current system-programmed data is printed out. The ranges are
as follows:
Manager : Manager Programming [000] through [009]
System : System Programming [100] through [148]
Timers : Timer Programming [200] through [219]
TRS/ARS : TRS/ARS Programming [300] through [334]
Outside line : CO Line Programming [400] through [417]
COS : COS Programming [500] through [509]
Extension : Extension Programming [600] through [610]
Resource : Resource Programming [800] through [815]
Option : Option Programming [990] through [991]
Selection • Printout range number:
(All) / 0 (Manager) / 1 (System) / 2 (Timer) /
3 (TRS/ARS) / 4 (Outside line) / 5 (COS) /
6 (Extension) / 8 (Resource) / 9 (Option)
• Start / Stop
Default Not applicable.
Programming 1. Enter 802.
Display: 802 SYSTEM DATA
2. Press NEXT.
Display: Enter Range?→
3. Enter a printout range number or for “All”.
Display: Print-Out:Start
4. Press STORE to start printing.
Printing starts.
To stop printing, press SELECT and go to step 5.
When printing is completed, the display shows:
Display: Print-Out:Finish
5. Press STORE.
Display: Print-Out:Stop
6. Press END.
To Next Page
Loading...
