4.6 Outside Line Programming
Outside Line Connection Assignment
400
4-94 System Programming
Description Used to identify the outside lines which are connected to the
system. This prevents users from originating a call to a line which
is not connected.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Connect / No Connect
Default All outside lines – Connect
Programming 1. Enter 400.
Display: 400 CO CONNECT
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:Connect
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all outside lines to one selection, press the key in step 3.
In this case, the display shows the contents programmed for outside line
1.
Feature References Section 3, Features
Outside Line Connection Assignment
To Next Page
Loading...
