R&S FSV3000 Series - Page 1138

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1138User Manual 1178.8520.02 ─ 01
INSTrument:COUPle:ACDC <State>
This command turns synchronization of the AC / DC Coupling state between measure-
ment channels on and off.
Parameters:
<State> ALL | NONE
ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: ALL
Example:
INST:COUP:ACDC ALL
Synchronizes the "AC/DC Coupling" parameter.
INSTrument:COUPle:ATTen
<State>
This command turns synchronization of the attenuation and unit between measure-
ment channels on and off.
Parameters:
<State> ALL | NONE
ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: ALL
Example:
INST:COUP:ATT ALL
Synchronizes the attenuation.
INSTrument:COUPle:BANDwidth <State>
INSTrument:COUPle:BWIDth <State>
This command turns synchronization of the resolution bandwidth (and filter type)
between measurement channels on and off.
Parameters:
<State> ALL | NONE
ALL | 1
Turns on synchronization.
NONE | 0
Turns on synchronization.
*RST: NONE
Example:
INST:COUP:BWID ALL
Synchronizes the resolution bandwidth.
Configuring the R&S FSV/A