R&S FSV3000 Series - Page 1158

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1158User Manual 1178.8520.02 ─ 01
SYSTem:PSA:WIDeband.............................................................................................. 1159
SYSTem:REVision[:STRing].......................................................................................... 1160
SYSTem:RSWeep........................................................................................................ 1160
SYSTem:HPCoupling <CouplingType>
Controls the default coupling ratios in the HP emulation mode for:
●
span and resolution bandwidth (Span/RBW) and
●
resolution bandwidth and video bandwidth (RBW/VBW)
This command is only available if a HP language is selected using SYSTem:LANGuage
on page 1159.
Parameters:
<CouplingType> HP | FSP
*RST: FSP
Example:
SYSTem:HPC HP
Manual operation: See "Coupling" on page 704
SYSTem:IFGain:MODE <Mode>
Configures the internal IF gain settings in HP emulation mode due to the application
needs. This setting is only taken into account for resolution bandwidth < 300 kHz and is
only available if a HP language is selected using SYSTem:LANGuage on page 1159.
Parameters:
<Mode> NORM | PULS
NORM
Optimized for high dynamic range, overload limit is close to ref-
erence level.
PULS
Optimized for pulsed signals, overload limit up to 10 dB above
reference level.
*RST: NORM
Example:
SYST:IFG:MODE PULS
Manual operation: See "IF Gain" on page 704
SYSTem:HPADditional <State>
Allows the use of HP commands in addition to SCPI commands for R&S
FSP/FSQ/FSU emulation (see SYSTem:LANGuage on page 1159).
Parameters:
<State> ON | OFF | 1 | 0
OFF | 0
Switches the function off
Emulating Other Instruments' Commands