R&S FSV3000 Series - Page 704

Network and Remote Operation
R&S
®
FSVA3000/ R&S
®
FSV3000
704User Manual 1178.8520.02 ─ 01
Remote command:
SYSTem:LANGuage on page 1159
IF Gain
Configures the internal IF gain settings in HP emulation mode due to the application
needs. This setting is only taken into account for resolution bandwidth < 300 kHz.
NORM Optimized for high dynamic range, overload limit is close to reference level.
PULS Optimized for pulsed signals, overload limit up to 10 dB above reference level.
This setting is only available if an HP language is selected (see "Language"
on page 703).
Remote command:
SYSTem:IFGain:MODE on page 1158
Sweep Repeat
Controls a repeated sweep of the E1 and MKPK HI HP model commands (for details
on the commands refer to Chapter 14.13.2, "Reference: GPIB Commands of Emulated
HP Models", on page 1160). If the repeated sweep is OFF, the marker is set without
sweeping before.
Note: In single sweep mode, switch off this setting before you set the marker via the
E1 and MKPK HI commands in order to avoid sweeping again.
This setting is only available if a HP language is selected (see "Language"
on page 703).
Remote command:
SYSTem:RSWeep on page 1160
Coupling
Controls the default coupling ratios in the HP emulation mode for:
●
span and resolution bandwidth (Span/RBW)
●
resolution bandwidth and video bandwidth (RBW/VBW)
For FSx, the standard parameter coupling of the instrument is used. As a result, in
most cases a shorter sweep time is used than in case of HP.
This setting is only available if a HP language is selected (see "Language"
on page 703).
Remote command:
SYSTem:HPCoupling on page 1158
Wideband
This setting defines which option is returned when the *OPT? query is executed,
depending on the state of the wideband option.
It is only available for PSA89600 emulation.
"Off"
No wideband is used.
The option is indicated as "B7J".
"40 MHz"
The 40 MHz wideband is used.
The option is indicated as "B7J, 140".
Network and Remote Control Settings