R&S FSV3000 Series - Page 341

Common Measurement Settings
R&S
®
FSVA3000/ R&S
®
FSV3000
341User Manual 1178.8520.02 ─ 01
Remote command:
SOURce<si>:EXTernal<gen>:FREQuency[:FACTor]:DENominator
on page 931
SOURce<si>:EXTernal<gen>:FREQuency[:FACTor]:NUMerator on page 932
SOURce<si>:EXTernal<gen>:FREQuency:OFFSet on page 932
Result Frequency Start
For reference only: The start frequency for the generator, calculated from the config-
ured generator frequency and the start value defined for the R&S FSV/A.
Result Frequency Stop
For reference only: The stop frequency for the generator, calculated from the config-
ured generator frequency and the stop value defined for the R&S FSV/A.
Source Calibration Functions
Access: [INPUT/OUPUT] > "External Generator Config" > "Source Calibration" tab
The calibration functions of the external generator are available only if external genera-
tor control is active (see " Source State " on page 339).
Calibrate Transmission................................................................................................342
Calibrate Reflection Short........................................................................................... 342
Calibrate Reflection Open...........................................................................................342
Source Calibration Normalize .................................................................................... 342
Recall ......................................................................................................................... 342
Data Input and Output