R&S FSV3000 Series - Page 951

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
951User Manual 1178.8520.02 ─ 01
[SENSe:]PMETer<p>:TRIGger:SLOPe <Edge>
This command selects the trigger condition for external power triggers.
Suffix:
<p>
.
Power sensor index
Parameters:
<Edge> POSitive
The measurement starts in case the trigger signal shows a posi-
tive edge.
NEGative
The measurement starts in case the trigger signal shows a neg-
ative edge.
*RST: POSitive
Example:
PMET2:TRIG:SLOP NEG
Manual operation: See " Slope " on page 322
[SENSe:]PMETer<p>:TRIGger[:STATe]
<State>
This command turns the external power trigger on and off.
Suffix:
<p>
.
Power sensor index
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
PMET2:TRIG ON
Switches the external power trigger on
Manual operation: See " Using the power sensor as an external trigger "
on page 321
14.7.6.5 Configuring the Outputs
The following commands are required to provide output from the R&S FSV/A.
Configuring trigger input/output is described in Chapter 14.7.4.3, "Configuring the Trig-
ger Output", on page 916.
DIAGnostic:SERVice:NSOurce........................................................................................952
OUTPut<up>:IF:IFFRequency.........................................................................................952
OUTPut<up>:IF:STATe................................................................................................... 952
OUTPut<up>:UPORt:STATe............................................................................................953
Setting Basic Measurement Parameters