R&S FSV3000 Series - Page 954

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
954User Manual 1178.8520.02 ─ 01
Suffix:
<up>
.
1..n
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Example:
OUTP:VID:STAT ON
Manual operation: See "Video Output State" on page 353
SYSTem:SPEaker[:STATe] <State>
This command switches the built-in loudspeaker on or off for demodulated signals.
This setting applies only to the current application.
The command is available in the time domain in Spectrum mode and in Analog
Demodulation mode.
To set the volume, use the SYSTem:SPEaker:VOLume command.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
SYST:SPE ON
SYST:SPE:VOL 0.5
Sets the loudspeaker to half the full volume.
Manual operation: See "State" on page 354
See "Loudspeaker" on page 459
SYSTem:SPEaker:MAXVolume <Volume>
Defines the maximum volume to be output as a percentage of the maximum possible
volume.
Parameters:
<Volume> percentage
Example:
SYST:SPE:MAXV 50
Manual operation: See "Max Volume" on page 355
SYSTem:SPEaker:MUTE
Temporarily disables the audio output via the built-in loudspeakers.
Setting Basic Measurement Parameters