R&S FSV3000 Series - Page 354

Common Measurement Settings
R&S
®
FSVA3000/ R&S
®
FSV3000
354User Manual 1178.8520.02 ─ 01
State............................................................................................................................354
Type............................................................................................................................ 354
Squelch ...................................................................................................................... 354
Squelch Level .............................................................................................................355
Audio Output Volume.................................................................................................. 355
Max Volume................................................................................................................ 355
State
If enabled, the demodulated audio signal is output to the IF connector (on the rear
panel of the R&S FSV/A).
This connector is only available if the R&S FSV3-B5 option is installed.
Note that output to the [AF Out] headphones connector on the front panel is always
possible, regardless of the audio output state.
Remote command:
SYSTem:SPEaker[:STATe] on page 954
Type
Defines the demodulation mode for output (AM/FM/PM). The default setting is AM.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:DEModulation:SELect on page 1030
Squelch
Activates or deactivates the squelch function. If activated, the audible AF is cut off
below a defined threshold level. Thus, you avoid hearing noise at the audio output
when no signal is available.
Data Input and Output