R&S FSV3000 Series - Page 990

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
990User Manual 1178.8520.02 ─ 01
CALCulate<n>:MARKer<m>:LOEXclude <State>
This command turns the suppression of the local oscillator during automatic marker
positioning on and off (for all markers in all windows).
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
CALC:MARK:LOEX ON
Manual operation: See " Exclude LO " on page 436
CALCulate<n>:MARKer<m>:PEXCursion
<Excursion>
This command defines the peak excursion (for all markers in all windows).
The peak excursion sets the requirements for a peak to be detected during a peak
search.
The unit depends on the measurement.
Application/Result display Unit
Spectrum dB
Suffix:
<n>
.
irrelevant
<m> irrelevant
Example:
CALC:MARK:PEXC 10dB
Defines peak excursion as 10 dB.
Manual operation: See " Peak Excursion " on page 436
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe] <State>
This command turns marker search limits on and off for all markers in all windows.
If you perform a measurement in the time domain, this command limits the range of the
trace to be analyzed.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
Analyzing Measurements (Basics)