R&S FSV3000 Series - Page 989

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
989User Manual 1178.8520.02 ─ 01
DISPlay[:WINDow<n>]:MINFo[:STATe] <DisplayMode>
This command turns the marker information in all diagrams on and off.
Suffix:
<n>
.
irrelevant
Parameters:
<DisplayMode> ON | 1
Displays the marker information in the diagrams.
OFF | 0
Hides the marker information in the diagrams.
*RST: 1
Example:
DISP:MINF OFF
Hides the marker information.
Manual operation: See " Marker Info " on page 433
CALCulate<n>:MARKer<m>:X:SSIZe <StepSize>
This command selects the marker step size mode for all markers in all windows.
It therefore takes effect in manual operation only.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<StepSize> STANdard
the marker moves from one pixel to the next
POINts
the marker moves from one sweep point to the next
*RST: POINts
Example:
CALC:MARK:X:SSIZ STAN
Sets the marker step size to one pixel.
Manual operation: See " Marker Stepsize " on page 434
14.8.3.3 Configuring and Performing a Marker Search
The following commands control the marker search.
CALCulate<n>:MARKer<m>:LOEXclude.......................................................................... 990
CALCulate<n>:MARKer<m>:PEXCursion.........................................................................990
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe].................................................................990
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT....................................................................991
CALCulate<n>:MARKer<m>:X:SLIMits:RIGHt...................................................................991
CALCulate<n>:MARKer<m>:X:SLIMits:ZOOM[:STATe]...................................................... 992
CALCulate<n>:THReshold..............................................................................................992
CALCulate<n>:THReshold:STATe....................................................................................993
Analyzing Measurements (Basics)