R&S FSV3000 Series - Page 993

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
993User Manual 1178.8520.02 ─ 01
Example:
CALC:THR -82DBM
Sets the threshold value to -82 dBm.
Manual operation: See " Search Threshold " on page 437
CALCulate<n>:THReshold:STATe <State>
This command turns a threshold for the marker peak search on and off (for all markers
in all windows).
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:THR:STAT ON
Switches on the threshold line.
Manual operation: See " Deactivating All Search Limits " on page 204
14.8.3.4 Positioning the Marker
This chapter contains remote commands necessary to position the marker on a trace.
● Positioning Normal Markers .................................................................................993
● Positioning Delta Markers..................................................................................... 997
Positioning Normal Markers
The following commands position markers on the trace.
CALCulate<n>:MARKer<m>:MAXimum:AUTO..................................................................993
CALCulate<n>:MARKer<m>:MAXimum:LEFT...................................................................994
CALCulate<n>:MARKer<m>:MAXimum:NEXT..................................................................994
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]................................................................ 994
CALCulate<n>:MARKer<m>:MAXimum:RIGHt..................................................................995
CALCulate<n>:MARKer<m>:MINimum:AUTO...................................................................995
CALCulate<n>:MARKer<m>:MINimum:LEFT....................................................................995
CALCulate<n>:MARKer<m>:MINimum:NEXT................................................................... 996
CALCulate<n>:MARKer<m>:MINimum[:PEAK]................................................................. 996
CALCulate<n>:MARKer<m>:MINimum:RIGHt...................................................................996
CALCulate<n>:MARKer<m>:MAXimum:AUTO <State>
This command turns an automatic marker peak search for a trace maximum on and
off. The R&S FSV/A performs the peak search after each sweep.
Suffix:
<n>
.
Window
Analyzing Measurements (Basics)