The connectors are coiled and tied above the PCB on the right.
6. Fasten the slide drive unit [A] to finisher and connect it to the punch unit ( x 2, x 1).
Press in on the slide drive unit at
when you attach screw .
7. Make sure that the punch unit moves freely and is not blocked by the screws.
8. Insert the side-to-side detection unit [A]. Make sure that the two pins are engaged correctly at
the front.
9. Confirm that the side-to-side detection slides smoothly on its rails. If it does not, make sure
that the rails are aligned with their grooves.
10. Fasten the side-to-side detection unit and connect it at the rear (
x 2, x 1, x 1).
11. Pull the short connector out of the connector [B] then connect it (
x 1).
This is the 3-pin connector.
To Next Page
Loading...
