Multi-Folding Unit FD4000 (D615)
D131/D132/D133 2-38 SM
Docking
1. Fasten the joint bracket [A] to the left side of the upstream unit ( x4 M4x20).
2. Open the front door [A].
3. At the front right corner, remove the screw of the lock bar [B] ( x1 M3x6). Keep this screw.
4. Pull out the lock bar.
If you are docking to the main machine, you must first remove the plastic cap at the
I/F cable connection point.
5. Slowly push the unit [C] against the left side of the upstream unit (or main machine) so that
the lock bar is directly and squarely under the arms of the joint bracket.
6. Push in the lock bar so it slides up into the notches in the arms on both ends of the joint
bracket [D].
7. Fasten the lock bar by re-attaching the screw removed in Step 3 (
x1).
8. Connect the I/F cable [E] to the upstream unit (or main machine).
To Next Page
Loading...
