Ricoh D131 - Toner Supply Motor

Development Unit
D131/D132/D133 4-62 SM
4.7.6 TONER SUPPLY MOTOR
1. Open the front door.
2. Swing the toner unit out of the machine and remove the toner bottle.
3. Bracket [A] (
x 1)
4. Lock plate [B] (
x 1)
 After re-installation, the tab [C] should be behind the stay and its pin below should be
in the open track below.
5. Toner bottle unit [A] (
x 1, harness x 1, x 1)
 The c-clamp is under the toner unit.
 Lift the toner bottle unit off the pegs and lay it on a piece of newspaper to avoid toner spill.
6. Bottom plate [B] (
x 3, harnesses x 2)
 2 screws on the bottom, 1 screw on the side.
7. Toner supply motor bracket [C] (
x 2)
8. Toner supply motor [D] (
x 2)