Ricoh D131 - Sc100: Scanning; Sc100

SC100: Scanning
D131/D132/D133 2-4 SM Appendix
2.2 SC100: SCANNING
2.2.1 SC100
SC101
D
Exposure Lamp Error
At trigger on, the lamp was not detected on.
-
 SBU board defective
 SIOB board defective
 IPU board defective
 BCU board defective
 Exposure lamp defective
 Lamp stabilizer defective
 Lamp stabilizer harness damaged, disconnected
 Standard white plate dirty, disconnected or has condensation
 DF white belt dirty
 DF glass dirty or has condensation
 Scanner mirror dirty, out of position or has condensation
 Lens dirty, out of position
SC120
D
Scanner home position error 1
The scanner HP sensor does not detect the OFF condition during
initialization or copying.
-
 BCU, SIOB defective
 Scanner motor defective
 Scanner HP sensor defective.
 Harness between BCU, SIOB, scanner motor disconnected.
 Harness between scanner HP sensor and BCU disconnected.
 Scanner wire, timing belt, pulley, or carriage installed incorrectly.