Cover Interposer Tray CI4000 (D614)
D131/D132/D133 2-80 SM
Attaching the Corner Plates for the D610
The corner plates are installed on the D610 only.
Right Rear Corner Plate (D610 only)
1. Temporarily attach the screws [A] (with about two turns) to the right end of the finisher
extension table [B] (
x 2, tapping M4 x 8)
The holes are not visible because they are covered with tape. Just punch the screws
through the holes.
2. Align the cutouts [C] of the right rear corner plate [D] with the screws and attach the plate.
3. With a long screw driver inserted through the cutouts in the right rear corner plate [D], tighten
the screws to fasten the right rear corner plate to the table extension [B].
4. Temporarily attach the screw [A] (M4 x 8) with about two turns to fasten to the panel at the
right front corner.
To Next Page
Loading...
