Ricoh D131 - Duplex Jogger Belt Adjustment

Duplex Unit
D131/D132/D133 4-96 SM
4.10.6 DUPLEX JOGGER BELT ADJUSTMENT
Remove:
 Cross stay
p.4-94
 Reverse trigger roller shaft
p.4-94
 Left half of the table
 Jogger motor bracket
 Slip the one end of the belt around the gear below the jogger motor.
 Slip the other end of the belt around the gear at the other side of the duplex unit.
1. If you are replacing the belt, set both jogger fence brackets at the center of the belt and
tighten the screw [A].
2. If you are adjusting the belt, loosen the screw and slide the plastic piece [B] on the belt to the
left or right to adjust the position of the front fence, then tighten the screw.