D619 26 SM
On the left, the upper harness is LINE 2 and the lower harness is LINE 3.
Make sure these harnesses are matched and connected with the LINE 2 and LINE 3
harnesses on the right. (The modules are clearly marked "LINE 2" and "LINE 3".
25. Reattach:
Controller box cover (
x 13).
Rear lower cover (
x 2).
Rear upper cover (
x 2).
Decal Attachment
1. Attach the fax function decal [A] to F5.
After fax installation, the fax function is assigned to F5. This is the default. You can
change the function key assignment with User Tools.
2. Attach the multi-language decal [B] (EU only).
3. Attach the FCC decal to the rear cover of the machine (NA only).
4. Connect the power plug to an outlet.
Make sure that the power outlet is grounded.
5. Turn the machine on. In the bottom left corner of the screen, a message will tell you that the
SRAM is being formatted.
6. When the reformat is finished, cycle the machine off and on again.
7. Enter User Tools and make sure that the date and time settings are set correctly.
To Next Page
Loading...
