Ricoh D131 - Errors During Firmware Update

Updating the Firmware
D131/D132/D133 5-18 SM
Errors During Firmware Update
If an error occurs during a download, an error message will appear. The error code consists of the
letter "E" and a number ("E20", for example).
Error Message Table
No. meaning Solution
20 Cannot map logical address
Make sure the SD card is installed correctly, or
use a different SD card.
21 Cannot access memory HDD connection not correct, or replace hard disk.
22
Cannot decompress
compressed data
The ROM data on the SD card is not correct, or
data is damaged.
23
Error occurred when ROM
update program started
Controller program defective. If the second
attempt fails, replace the controller board.
24 SD card access error
Make sure the SD card is installed correctly, or
use a different SD card.
30
No HDD available for stamp
data download
HDD connection not correct or replace hard disks.
31
Data incorrect for continuous
download
Install the SD card with the remaining data
necessary for the download, then re-start the
procedure.
32
Data incorrect after download
interrupted
Do the recovery procedure for the module, then
repeat the installation procedure.
33 Incorrect SD card version
The ROM data on the SD card is not correct, or
data is damaged.