Preparing the Finisher
1. Remove the cover [A] of the relay connector.
2. Loosen the screw of the bracket [B] (
x 1) then remove the bracket.
3. Remove the guide plate [C]. (This guide plate will be attached to the cover interposer; do not
discard it.)
If you are installing the cover interposer tray with a previously installed finisher,
remove the sponge strip from the finisher and save it for re-attachment to the
interposer tray.
4. Either:
If you are installing the D611/D612, attach the extensions to the finisher without
modification. Go to "Attaching the Extensions for the D611/D612".
If you are installing the D610, modify the extensions and attach them to the finisher. Go to
"Attaching the Extensions for the D610".
To Next Page
Loading...
