Ricoh D131 - Re-Installation; Transfer Power Pack

Transfer Belt Unit
SM 4-69 D131/D132/D133
Replacement
and
Adjustment
4.8.5 TRANSFER POWER PACK
Remove:
 Transfer belt unit
p.4-64
1. Wire (
x 1) [A] (all wire guides)
2. Ground terminal wire [B] (wire guide x 1)
 This terminal wire does not disconnect from the power pack.
 Loosen the two left screws of the transfer belt lift solenoid [C], and remove the top screw
[D] to free the ground terminal wire.
3. Transfer current terminal wire [E] (wire guides x 2)
4. Transfer power pack [F] (
x 1)
 Disconnect the two standoffs on the right edge of the power pack and remove.
Re-installation
 Confirm that the left edge of the power pack is below the tabs on the left.
 Confirm that the transfer current terminal wire is below the wire guides on the right.
 Pass the ground terminal wire under the top connector of the solenoid bracket and tighten all
the screws of the solenoid bracket.
 Make sure the wire is below all the wire guides at the top.