Ricoh D131 - Attaching the Extensions for the D611;D612

Cover Interposer Tray CI4000 (D614)
D131/D132/D133 2-78 SM
 Attach this cover first.
6. Attach the top front cover extension [E] (
x 2, M4 x 8).
7. Set two screws into the holes provided for the rear cover extension [F] (
x 2, M3 x 6).
8. Set the keyholes of the rear cover extension over of the heads of the screws.
9. Press up on the bottom of the rear cover extension to close the gap at the top of the cover,
then tighten the screws.
Attaching the Extensions for the D611/D612
1. Attach the three shoulder screws [A]
( x 3).
2. If the finisher has been previously installed, remove the ground plate [B] from the finisher and
save the screws
3. Attach the bottom plate [C] (
x 2, M3 x 6) then attach the ground plate to the bottom plate (
x 2).
4. Attach the bottom front cover extension [D] (
x 2, M4 x 8).
5. Attach the top front cover extension [E] (
x 2, M4 x 8).
6. Attach the rear cover extension [F] (
x 2, M3 x 6).