Service
Program
Mode Tables
3.4 SP3000 PROCESSING
3001 ID Sensor Initial Setting
1 ID Sensor PWM Setting
Recovers the machine when an SC is logged because the ID Sensor Initial
Setting is not done after doing an NVRAM Clear or replacing the NVRAM.
Reset this SP to the factory setting in this case.
[0 to 255/70/1]
2 ID Sensor Initialization
Performs the ID sensor initial setting. The ID sensor output for the bare drum
(VSG) is adjusted to 4.0 ± 0.2V.
Press "Execute".
This SP mode should be performed after:
(1) Replacing or cleaning the ID sensor, (2) Replacing the NVRAM, (3)
Clearing NVRAM, (4) Replacing the BICU board.
To Next Page
Loading...
