Ricoh D131 - Installation

Copy Connector Type 3260 (B328)
SM 2-99 D131/D132/D133
Installation
2.18.3 INSTALLATION
1. Remove these parts:
 Rear upper cover (
x2)
 Rear lower cover (
x2)
 Controller box cover (
x 13)
2. Remove the cover [A] of Slot B (
x 2).
3. Install the Copier Connection Kit Board B328 [B] in Slot B and fasten it (
x 2).
4. Connect the power repeater cable [C] to:
 CN32 on the controller board
 CN4 on the copy connector board
5. Reattach the controller box cover, rear upper and lower cover.
Repeat Steps 1 to 5 to install the connector kit on the second machine.
6. Connect the end of the interface cable [D] to the copy connector board.
7. Attach the ferrite cores [E] to both ends of the interface cable.
8. If and additional cable is required, connect the repeater hub [F] and cable [G].
9. Attach the appropriate decal [H] to each machine.
10. Attach the "Printer/Other Function" decal (or its equivalent symbol for EU) if the
printer/scanner option is installed.
-or-
Attach the "Other Function" decal (or its equivalent symbol for EU) if the printer/scanner
option is not installed.
11. Attach the other end of the connection cable to the copy connector board installed in the other
machine.