Ricoh D131 - Cleaning Brush

Drum Unit
SM 4-45 D131/D132/D133
Replacement
and
Adjustment
4.6.10 CLEANING BRUSH
Remove:
 OPC drum
p.4-40
 Drum cleaning blade
p.4-44
1. Coupling [A] (
x 1)
2. Inner bushing [B] (
x 1)
3. Cleaning brush [C]
 Pull the shaft toward the rear to disengage the front of the shaft, then pull out.
 After replacing the cleaning brush, clean the ID sensor to make sure that it is clean
and free of toner.
 Avoid touching the cleaning brush with bare hands.
 Check the entrance seals and confirm that they are not bent.