Ricoh D131 - Feed Belt and Pick-Up Roller

ADF
D131/D132/D133 4-138 SM
4.13.3 FEED BELT AND PICK-UP ROLLER
1. Remove the feed unit.
p.4-137
2. Remove the pick-up roller unit [A].
3. Remove the bushings [B].
4. Remove the pick-up roller [C].
 At re-assembly, make sure that the tab on the front guide plate is above the pick-up
roller.
5. Hold the feed belt holder [A] by the left and right sides, then carefully pull it off the bushing. Do
not let the springs [B] fall.
6. Remove the feed belt [C].
 When re-assembling, set the pick-up roller springs first, then follow this procedure in
reverse.