Prepare the Cover Interposer for the D610
1. Remove spacer [A] (
x 1).
2. Attach spacer [B] (
x 1).
3. Remove the screws from the connector case [C] (
x 2).
4. Push the connector case in the direction of the arrow until the second set of holes is aligned
with the holes below, then attach the screws.
Attach the Extensions to the D610
1. Attach the three shoulder screws [A] ( x 3).
2. If the finisher has been previously installed, remove the ground plate [B] from the finisher and
keep the screws.
3. Attach the bottom plate [C] (
x 2, M3 x 6).
4. Attach the ground plate to the bottom plate (
x 2).
5. Attach the bottom front cover extension [D] (
x 2, M4 x 8).
To Next Page
Loading...
