Punch Units (B702)
D131/D132/D133 2-66 SM
2.11.2 INSTALLATION PROCEDURE
Always turn the machine off and unplug the machine before doing any of the following
procedures.
1. If the finisher is connected to the copier, disconnect the power connector [A] and separate the
finisher from the copier.
2. Remove the rear cover [B] (
x 2) and open the front door.
At the base of the back cover, be sure to disconnect the tabs that fasten the cover to
the frame.
3. Remove the guide plate [C] (
x 2).
4. Slide the punch unit [A] along its rails into the finisher. Make sure that pin engages correctly at
the front and rear.
5. Connect and fasten the punch unit [B] (
x 2, x 1).
To Next Page
Loading...
