LCIT RT4010 (D613)
D131/D132/D133 2-26 SM
Preparing the Main Machine
Switch the machine off and unplug the machine before starting the following procedure.
1. Remove the LCT installation cover [A] from the right side of the machine (
x 2).
2. Save the screw on the left [B]. You will need it to install the LCT.
3. Remove the LCT connector cover [C] (x 1) and the covers over the holes for the docking pins
[D]. (x 3)
Installing the LCT
1. Insert the two upper docking pins (grooved) [A] into the upper slots and the lower docking pin
[B] into the lower slot.
To Next Page
Loading...
