ADF
D131/D132/D133 4-154 SM
6. Slowly loosen the rear lock screw [E] until you see the tip of the shaft aligned with the hole
, then tighten the screw.
7. Re-install the Teflon sleeve.
8. Re-install the front and rear plastic cover.
9. Reinstall the transport belt assembly in the ADF.
Reattaching the White Cover
1. With its white side down, set the cover [A] on the exposure glass.
2. Make sure the upper left corner is aligned with the arrow at the corner of the exposure glass.
3. Close the ADF [B] on top of the cover.
To Next Page
Loading...
