Ricoh D131 - Transfer Belt Unit; Transfer Belt Unit Removal

Transfer Belt Unit
D131/D132/D133 4-64 SM
4.8 TRANSFER BELT UNIT
4.8.1 TRANSFER BELT UNIT REMOVAL
 Before you begin, spread a mat or some clean paper on the floor where you intend to set
the transfer belt unit.
Remove:
 OPC drum unit
p.4-40
1. Disconnect the transfer belt unit [A] (
x 1).
2. Remove the transfer belt unit stay [B] (
x 1).
3. While supporting the transfer belt unit with your hand, turn the release lever [C]
counter-clockwise to release it, then pull the transfer belt unit out of the machine.
 The transfer belt unit can be removed without removing the OPC drum unit.
 However, the transfer belt unit must be removed carefully to avoid scratching the
surface of the transfer belt on the OPC drum unit [D].
 Avoid touching the belt with bare hands.