2.8 PUNCH UNITS (B531/A812)
This procedure describes installation of these punch units in the Finisher SR4080.:
Punch Unit Type 1075 3/2 (B531)
Punch Unit Type 1075 EU 2/4 (B531)
Punch Unit Type 850 SC (A812)
These punch units can be installed and used with the Finisher SR4080 only.
2.8.1 ACCESSORY CHECK
Check the accessories and their quantities against this list:
No. Description Q"ty
1. Punch unit 1
2. Harness Connector Cable - PCB 1
3. Harness Connector Cable - HP Sensor 2 1
4. Harness Connector Cable - HP Sensor 1, Hopper Full 1
5. Sensor Arm and Sensor 1
6. Spacer (2 mm) 1
7. Spacer (1 mm) 2
8. Spring 1
9. Step Screw (large) (M4 x 11) 1
10. Tapping Screw (M4 x 10) 2
11. Step Screw (small) (M3 x 4) 1
12. Machine Screw, Washer (M4 x 6) 1
13. Knob 1
14. Punch Waste Hopper 1
To Next Page
Loading...
