Finisher SR4080 (D610)
D131/D132/D133 2-46 SM
10. Open the front door of the finisher, and remove the screw from the locking lever, then pull out
the locking lever [B].
11. Align the finisher on the joint brackets, and lock it in place by pushing in the locking lever [B].
Before securing the locking lever, make sure that the top edges of the finisher and
the copier are parallel from front to rear as shown [C].
12. Secure the locking lever [B] (
x 1) and close the front door.
13. Connect the finisher cable [D] to the copier.
14. Set the leveling shoes (x 4) under the feet and level the machine.
To Next Page
Loading...
