Ricoh D131 - Transfer Belt Removal

Transfer Belt Unit
SM 4-65 D131/D132/D133
Replacement
and
Adjustment
4.8.2 TRANSFER BELT REMOVAL
Remove:
 Transfer belt unit
p.4-64
1. Disconnect the earth terminal [A] and transfer current terminal [B] (
x 2). While doing this,
hold the transfer belt unit [C] by its knobs [D].
2. Raise and stand the belt perpendicular to the unit and remove it.
 To avoid scratching the belt on the guide, never rotate the belt unit farther than 90
degrees.
3. Release the drive roller [E] (
x 2).
4. Press in on the drive roller to collapse the unit into a “U” shape [F].
5. Remove the belt and replace it.