Transfer Belt Unit
D131/D132/D133 4-68 SM
4.8.4 DISCHARGE PLATE
1. Remove the transfer belt unit
p.4-64
2. Remove the shoulder screw and spring [A] (
x1, Spring x1).
3. Rotate the discharge unit up, then lift it straight up to remove it.
4. Disconnect the three large tabs [B].
5. Remove the bracket [C] (
x 1).
6. Disconnect the 6 small seal case tabs [D].
7. Remove the discharge plate [E].
Reinstallation
1. Set the discharge plate and make sure that it is perfectly flat before re-connecting the tabs.
2. Before re-attaching the bracket [C], make sure that all the tabs are connected.
To Next Page
Loading...
