Ricoh D131 - Tandem Tray Side Registration

Paper Feed
SM 4-107 D131/D132/D133
Replacement
and
Adjustment
4.11.7 TANDEM TRAY SIDE REGISTRATION
Normally the side registration of the image can be adjusted in the SP mode.
If the punch hole positions are not aligned from a particular feed station, however, you can
manually adjust the side registration by changing the tray cover position for that tray, and then
adjust the side registration of the image
p.4-155
1. Pull out the tray and remove the right inner cover [A] (
x 2).
2. Loosen the screws and adjust the position of the plate [B].
 Adjustment range: 0 ± 2.0 mm adjustment step: 1.0 mm/step