Ricoh D131 - Page 371

Updating the Firmware
SM 5-19 D131/D132/D133
System
Maintenance
34
Module mismatch - Correct
module is not on the SD card
The data on the SD is not correct. Get the correct
data (Japan, Overseas, OEM, etc.) then install
again.
35
Module mismatch – Module on
SD card is not for this machine
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
36
Cannot write module – Cause
other than E34, E35
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
40
Engine module download
failed
Replace the data for the module on the SD card
and try again, or replace the BCU board.
42
Operation panel module
download failed
Replace the data for the module on the SD card
and try again, or replace the LCDC.
43
Stamp data module download
failed
Replace the data for the module on the SD card
and try again, or replace the hard disk.
44
Controller module download
failed
Replace the data for the module on the SD card
and tray again, or replace the controller board.
50
Electronic confirmation check
failed
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.